Search results for "frequency [modulation]"

Evaluating the presence of microplastics in striped dolphins (Stenella coeruleoalba) stranded in the Western Mediterranean Sea.

2020

Litter is a well-known problem for marine species; however, we still know little about the extent to which they're affected by microplastics. In this study, we analyse the presence of this type of debris in Western Mediterranean striped dolphins' intestinal contents over three decades. Results indicated that frequency was high, as 90.5% of dolphins contained microplastics. Of these microplastics, 73.6% were fibres, 23.87% were fragments and 2.53% were primary pellets. In spite of the high frequency of occurrence, microplastic amount per dolphin was relatively low and highly variable (mean ± SD = 14.9 ± 22.3; 95% CI: 9.58–23.4). Through FT-IR spectrometry, we found that polyacrylamide, typic…

In vitro comparison of primary stability of two implant designs in D3 bone

2016

Background Primary stability (PS) is a key factor for implant survival rate and depends on implant design or bone quality. The aim of this study was to compare different thread designs implants, evaluating PS with periotest values (PV) and implant stability quotient (ISQ) values through resonance frequency analysis (RFA). Material and Methods A total of 60 implants (Radhex®, Inmet-Garnick S.A., Guadalajara, Spain) were placed in freshly bovine ribs in vitro. Two designs were used: 30 tapered body with single thread design (PHI) and 30 tapered body with double thread design implants (PHIA). Both designs were 4mm wide and 12mm long. Implants were placed according to manufacturer’s guidelines.…

Minimal-model for robust control design of large-scale hydraulic machines

2018

Hydraulic machines are in use where the large forces, at relatively low velocities, are required by varying loads and often hazardous and hard-to-reach environments, like e.g. offshore, mining, forestry, cargo logistics, and others industries. Cranes and excavators equipped with multiple hydraulic cylinders are typical examples for that. For design of the robust feedback controls of hydraulic cylinders, already installed into large-scale machines, there is a general lack of reliable dynamic models. Also the suitable and feasible identification techniques, especially in frequency domain, yield limited. This paper pro­poses a minimal-modeling approach for determining the most relevant open-lo…

Fractional-Order System Identification of Viscoelastic Behavior: A Frequency Domain Based Experimental Study

2020

In this work, the fractional-order modeling of viscoelastic behavior is investigated based on measurement data in the frequency domain. For the results of two different test setups we apply existing parameter estimation algorithms designed for fractional-order transfer functions. These algorithms require a priori knowledge of the system structure including the commensurate order of differentiation. An iterative procedure is used to evaluate the influence of the unknown structure. The measured polymer samples show a viscoelastic stress response. We can show that integer-order models are not capable of capturing this behavior. For a set of predefined structures, the best obtained fractional-o…

A Fractional-Order Control Approach to Ramp Tracking with Memory-Efficient Implementation

2020

We investigate the fractional-order (FO) control of arbitrary order LTI systems. We show that, for ramp tracking or input disturbance rejection, it is advantageous to include an FO integrator to the open-loop if we have to increase the order of integration further than one. With the lower phase-loss of the FO integrator it is easier to guarantee a desired phase margin. Furthermore the flat phase response around the crossover-frequency (iso-damping property) can be achieved for a wider frequency range such that the closed-loop is more robust wrt. amplitude and phase margins. The drawback of the FO approach is the increased implementation effort and the algebraic decay, which slows down the t…

Frequency-domain experimental setup for mechatronic and suspension system components

2021

This paper presents a frequency-domain experimental setup for modal analysis of mechatronic and suspension system components. Design, instrumentation and dynamic behavior of the one degree-of-freedom (DOF) system, capable of providing both, periodic and application-specific, excitation forces is described. The excitation is realized by an electromagnetic modal shaker with additional assembly and interface components designed and instrumented for frequency -domain analysis of vertical dynamics. Frequency response functions (FRFs) of the implemented system are experimentally measured and the associated basic model parameters are calculated, correspondingly identified. Accurate fit between the…

Design of a robust controller for DC/DC converter–electrolyzer systems supplied by μWECSs subject to highly fluctuating wind speed

2020

Abstract A buck-based, isolated, high-voltage-ratio DC/DC converter that allows supplying a proton exchange membrane (PEM) electrolyzer from a micro-wind energy conversion system ( μ WECS) has been recently presented. It exhibits low ripple at the switching frequency on the output voltage and current and represents an attractive solution for low-cost hydrogen production. In this paper, a more accurate mathematical model of such a converter is derived and discussed. Then, a model-based robust controller is designed in the frequency domain using the Internal Model Control structure and in the context of H 2 ∕ H ∞ optimal control. The controller satisfies the condition of robust stability and …

Local field potential activity dynamics in response to deep brain stimulation of the subthalamic nucleus in Parkinson's disease

2020

Abstract Local field potentials (LFPs) may afford insight into the mechanisms of action of deep brain stimulation (DBS) and potential feedback signals for adaptive DBS. In Parkinson's disease (PD) DBS of the subthalamic nucleus (STN) suppresses spontaneous activity in the beta band and drives evoked resonant neural activity (ERNA). Here, we investigate how STN LFP activities change over time following the onset and offset of DBS. To this end we recorded LFPs from the STN in 14 PD patients during long (mean: 181.2 s) and short (14.2 s) blocks of continuous stimulation at 130 Hz. LFP activities were evaluated in the temporal and spectral domains. During long stimulation blocks, the frequency …

2017

Functional near infrared spectroscopy (fNIRS) is a promising neuroimaging method for investigating networks of cortical regions over time. We propose a directed effective connectivity method (TPDC) allowing the capture of both time and frequency evolution of the brain’s networks using fNIRS data acquired from healthy subjects performing a continuous finger-tapping task. Using this method we show the directed connectivity patterns among cortical motor regions involved in the task and their significant variations in the strength of information flow exchanges. Intra and inter-hemispheric connections during the motor task with their temporal evolution are also provided. Characterisation of the …

Generation and Coherent Control of Pulsed Quantum Frequency Combs

2018

We present a method for the generation and coherent manipulation of pulsed quantum frequency combs. Until now, methods of preparing high-dimensional states on-chip in a practical way have remained elusive due to the increasing complexity of the quantum circuitry needed to prepare and process such states. Here, we outline how high-dimensional, frequency-bin entangled, two-photon states can be generated at a stable, high generation rate by using a nested-cavity, actively mode-locked excitation of a nonlinear micro-cavity. This technique is used to produce pulsed quantum frequency combs. Moreover, we present how the quantum states can be coherently manipulated using standard telecommunications…